Intek 18x20 Infrared Heating Panel with oven - $399 (Mineola)

Please read this description carefully.
This listing is for two things: an Intek Infrared Heating Panel - used as a flash dryer for T-shirts, sublimation, etc.
18x20.
240.
3015 element (3015W / 240V / 13 Amps) flash dryer - a $750 value The heating element worked fine the last time I tested it about a year ago.
Also included is a custom built oven - aluminum sheets with Rockwool insulation inside and one pull out drawer as shown.
The aluminum sheets alone 3003H14 0.
032 in.
cost over $800 today, not counting the $100+ in additional parts and metal tapping screws.
This is a project oven, for parts or repair, considered not working.
It runs on 240V, 20 amp line, so you need a special power line.
Currently the infrared heater is installed inside the oven but I have the parts to put it back to its original form as shown in one of the photos.
You would need to take apart the oven to unscrew the heating element.
I am unable to test anything with electrical power before you take it.
For safety reasons the electrical plug cannot be included - you'll need to consult your electrician before powering anything.
Please be aware that the edges are all very sharp as I did not cover them with duct tape.
Bring thick tarps and sheet metal gloves, etc.
to protect yourself and your van.
You can see one side is missing the insulation and sheet metal cover.
I can include the extra sheet metal and insulation if you'd like it.
You get everything for the value of the infrared panel essentially.
You must take everything; I can't take it apart to give you only one or more of the parts.
Local pickup only, cash only.